Product Overview
1. Hood strap
2. Parking brake
Controls
1. Brake pedal
2. Parking brake, center
console
3. Steering wheel
4. Cup holder
Accelerator Pedal
The accelerator pedal (Figure 9) gives the operator the
ability to vary ground speed of the vehicle. Pressing the
pedal when the On/Off switch is On starts the motor.
Pressing the pedal farther increases ground speed.
3. Cargo box
4. Cargo box release lever
Figure 9
5. Passenger hand hold
6. Operator's Manual tube
7. Accelerator pedal
Figure 8
Releasing the pedal will slow the vehicle and the motor
will stop.
Note: Pressing down on the pedal and holding it
there before the key is turned to the On position will
cause a safety interlock to engage and the machine will
not operate. Release the pedal and the interlock will
disengage and allow normal operation of the machine
to resume.
Brake Pedal
The brake pedal is used to stop or slow the vehicle
(Figure 9).
CAUTION
Brakes can become worn or can be incorrectly
adjusted resulting in personal injury.
If brake pedal travels to within 1 inch (25 mm) of
the vehicle floor board, the brakes must be adjusted
or repaired.
Parking Brake
The parking brake is between the seats (Figure 9).
Whenever the vehicle is shut off, the parking brake
must be engaged to prevent accidental movement of
the vehicle. To engage the parking brake, pull back on
15
5. Charging receptacle
6. Towing tongue