Setup; Installing The Steering Wheel; Installing The Batteries - Toro 07299 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Note: Determine the left and right sides of the machine
from the normal operating position.
1

Installing the Steering Wheel

Parts needed for this procedure:
1 Steering wheel
Procedure
Note: This procedure is only needed for Model No.
07299TC.
1. Release the tabs on the back of the steering wheel
that hold the center cover in place. Remove the cover
2. Remove the nut and washer from the steering shaft.
3. Slide the steering wheel and washer onto the shaft.
Position the steering wheel on the shaft so that the
cross beam is horizontal when the tires are pointed
Description
Steering wheel
Battery hold down
Battery hold down rod
Battery cables
Battery tray pads
Battery pad
Flange nut (3/8 inch)
Battery terminal protector spray
No parts required
No parts required
Operator's Manual
Parts Catalog
Safety Training material
Registration Card
Predelivery Inspection Form
Certificate of Quality
Key
Qty.
Install the steering wheel (Model
1
07299TC only).
2
2
7
Install the batteries (Model 07299TC
4
only).
1
2
1
–
Check the tire pressure.
Set the charger voltage (Model 07299TC
–
only).
1
1
1
Read the Operator's Manual and view
1 the training material before operating
the machine.
1
1
2
straight ahead and the thicker spoke of the steering
wheel is downward.
4. Secure the steering wheel to the shaft with the nut
(Figure 3). Torque the nut to 18-22 ft-lb (24-29 N-m)
1. Steering shaft
2. Foam seal
3. Steering wheel
4. Tab slots in wheel
5. Snap the center cover in place.
11
Use
Figure 3
5. Washer
6. Nut
7. Cover
8. Tabs in cover