Checking The Stabilizer Bushing; Lubricating The Rear Knuckle Pivots; Lubricating The Drive Shaft Universal Joints; Checking The Engine Mount - Yamaha Wolverine YX70EPNG Service Manual

1 2
d. Tighten the tie-rod end locknuts to specifica-
tion.
Tie-rod end locknut
40 Nm (4.0 m·kgf, 29 ft·lbf)
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
4. Check:
• Steering wheel
TIP
After adjusting the toe-in, the steering wheel
should be centered.
Refer to "INSTALLING THE STEERING
WHEEL" on page 4-16.
EBS30064

CHECKING THE STABILIZER BUSHING

1. Check:
• Stabilizer bushings
Damage/wear → Replace.
Refer to "REAR KNUCKLES AND STABILIZ-
ER" on page 4-60.
EBS30065
LUBRICATING THE REAR KNUCKLE
PIVOTS
1. Remove:
• Rear arm protectors
2. Lubricate:
• Rear knuckle pivots
Recommended lubricant
Lithium-soap-based grease
2
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
PERIODIC MAINTENANCE
EBS30066
LUBRICATING THE DRIVE SHAFT
1
UNIVERSAL JOINTS
1. Remove:
• Center cover
Refer to "GENERAL CHASSIS (3)" on page
4-6.
2. Lubricate:
• Drive shaft universal joint
▲▲▲
EBS30067

CHECKING THE ENGINE MOUNT

1. Check:
• Engine brackets
Cracks/damage → Replace.
• Engine mounting bolts
• Engine bracket nuts
Loosen → Tighten.
Refer to "ENGINE REMOVAL (2)" on page
5-5.
EBS30068
CHECKING THE CONSTANT VELOCITY
SHAFT ASSEMBLY DUST BOOTS
1. Check:
• Dust boots "1"
Damage → Replace.
Refer to "FRONT CONSTANT VELOCITY
SHAFT ASSEMBLIES, DIFFERENTIAL AS-
SEMBLY AND FRONT DRIVE SHAFTS" on
page 8-4 and "REAR CONSTANT VELOCI-
3-33
Recommended lubricant
Lithium-soap-based grease