Troubleshooting - Canon MVX150i Instruction Manual

6_D74PAL_E(139-159)

Troubleshooting

If you have a problem with your camcorder, refer to this checklist. Consult your dealer
or a Canon Service Centre if the problem persists.
Power Source
Camcorder will not turn
on.
The camcorder switches
off by itself.
Cassette compartment
will not open.
Cassette compartment
stopped during loading/
unloading.
LCD/viewfinder switches
on and off.
Recording/Playback
Buttons will not work.
k flashes on the
screen.
h flashes on the screen.
"Remove the cassette"
appears on the screen.
The wireless controller
will not work.
Downloaded From CamcorderManual.com Canon Manuals
03.1.27 7:50 PM
Problem
Battery pack is exhausted.
Battery pack is not correctly
attached.
Battery pack is exhausted.
Power save function has
been activated.
Battery pack is exhausted.
Cassette compartment cover
is not fully open.
Battery pack is exhausted.
The camcorder
malfunctions.
Battery pack is exhausted.
Camcorder is not turned on.
Cassette is not loaded.
Battery pack is exhausted.
Condensation is detected.
Camcorder stopped
operating to protect the
tape.
Camcorder and wireless
controller are not set to the
same remote sensor mode.
Batteries of the wireless
controller are exhausted.
Page 149
Cause
Replace or charge the
battery pack.
Attach the battery pack
correctly.
Replace or charge the
battery pack.
Turn on the camcorder.
Replace or charge the
battery pack.
Open the cassette
compartment cover fully.
Replace or charge the
battery pack.
Consult a Canon Service
Centre.
Replace or charge the
battery pack.
Turn on the camcorder.
Load a cassette.
Replace or charge the
battery pack.
See reference page.
Unload and reload the
cassette.
Change the remote sensor
modes.
Replace the batteries.
Solution
14
14
14
26
14
20
14
–
14
26
20
14
147
20
47
22
E
149