Makita LW1400 Instruction Manual page 7

Opening center cap type safety
guard
Country specific
For the tools equipped with center cap type safety
guard, loosen the clamping screw first then raise the
guard.
1
► 1 . Clamping screw
Opening European type safety
guard
Country specific
For the tools equipped with European type safety guard,
loosen the clamping screw first then open the guard as
shown.
1
► 1 . Clamping screw
Removing or installing cut-off wheel
CAUTION:
Be sure to tighten the toolless
clamp or hex bolt securely. Insufficient tightening
may result in severe injury. When tightening the hex
bolt, use the socket wrench provided with the tool to
assure proper tightening.
CAUTION:
Always use only the proper inner
and outer flanges which are provided with the
tool.
CAUTION:
Always lower the safety guard
after replacing the wheel.
1
2
► 1 . Inner flange 2. Ring 3. O-ring 4. Cut-off wheel
5. Outer flange 6. Toolless clamp / Hex bolt
For LW1400
Raise the safety guard. Turn the toolless clamp coun-
terclockwise while holding down the shaft lock. Then
remove the toolless clamp, outer flange and cut-off
wheel. When removing the cut-off wheel, do not remove
the inner flange as well as the ring and O-ring.
7 ENGLISH
3
4
5
6