Advertisement
IF USED AS A GRINDER
NOTE:
Use grinder accessories specified in this manual. These must be purchased by separate.
WARN IN
G :
Always use guard assembly or accessory kit, noted below, for type 27 depressed center
wheel.
Guard assembly
Guard accessory kit
Part
No.
192578-8
...
For 180 mm (7")
Part No. 192588-5
...
For 230
mm
(9")
Part No. 192606-9
...
For
180 mm
(7")
Part No. 192607-7
...
For 230
mm
(9")
Installing wheel guard
CAUTION:
Always be sure that the tool is switched off and unplugged before installing or removing
the wheel guard.
When using a depressed center wheel or an
abrasive cut-off wheel, always use a wheel
guard. Mount the wheel guard with the tab
on the wheel guard band aligned with the
notch on the bearing box. Then rotate the
wheel guard 160 degrees counterclockwise.
Be sure to tighten the screw securely.
wheel
guard
Installing
or
removing depressed center wheel
CAUTION:
Always be sure that the tool is switched off and unplugged before installing or removing
the wheel.
Mount the inner flange onto the spindle. Fit
the wheel on over the inner flange and screw
the lock nut onto the spindle.
Lock nut
Depressed
center wheel
Inner flange
8
Advertisement
