Inner Flange 35; Lock Nut; Plastic Pad; Flex Wheel - Makita 9560CV Instruction Manual

1
1. Screw
1

1. Lock nut

2. Depressed center grinding wheel/
Multi-disc

3. Inner flange

4. Spindle
1
2

1. Lock nut wrench

2. Shaft lock
1. Lock nut

2. Flex wheel

3. Plastic pad

4. Inner flange
8
Loosen the lever on the wheel guard. Mount the wheel guard
002981
with the protrusion on the wheel guard band aligned with the
notch on the bearing box. Then rotate the wheel guard
around 180 degrees. Tighten the lever to fasten the wheel
guard. If the lever is too tight or too loosen to fasten the
wheel guard, loosen or tighten the screw to adjust the tight-
ening of the wheel guard band.
To remove wheel guard, follow the installation procedure in
reverse.
Installing or removing depressed center grinding
002982
wheel/Multi-disc
2
3 WARNING:
• Always use supplied guard when depressed center
4
grinding wheel/Multi-disc is on tool. Wheel can shatter
during use and guard helps to reduce chances of
personal injury.
Mount the inner flange onto the spindle. Fit the wheel/disc on
the inner flange and screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock firmly so that the
001084
spindle cannot revolve, then use the lock nut wrench and
securely tighten clockwise.
To remove the wheel, follow the installation procedure in
reverse.
Installing or removing flex wheel
001096
1
(optional accessory)
2
3
WARNING:
4
• Always use supplied guard when flex wheel is on tool.
Wheel can shatter during use and guard helps to reduce
chances of personal injury.
Follow instructions for depressed center grinding wheel/
Multi-disc but also use plastic pad over wheel. See order of
assembly on accessories page in this manual.