Specifications; Resetting The System - Sony CMT-VP1 Operating Manual

Troubleshooting (continued)
Tuner
There is a severe hum or noise ("TUNED"
or "STEREO" flashes).
• Adjust the antenna.
• The signal strength is too weak. Connect an
external antenna (see page 11).
• Make sure that the antenna is connected
properly.
• Do not bend or roll up the antenna.
• The two wires comprising the FM antenna
have been pulled further apart since the
system was first purchased. Repair or replace
with a new one.
• The AM antenna wire is detached from the
stand.
A stereo FM program cannot be received
in stereo.
• Press STEREO/MONO on the remote until
"STEREO" appears in the display.

Resetting the system

1 Disconnect the power cord from the wall outlet.
2 Press ?/1 down and connect the power cord to
the wall outlet again.
The system is reset to the factory settings. All
previous settings such as the preset stations, clock,
and timers are cleared and must be set again.
40

Specifications

Amplifier section
The following measured at 230 V AC, 60 Hz
DIN power output (rated): 20 + 20 W
(6 ohms at 1 kHz, DIN)
Continuous RMS power output (reference):
25 + 25 W
(6 ohms at 1 kHz, 10% THD)
The following measured at 220 V AC, 60 Hz
DIN power output (rated): 18 + 18 W
(6 ohms at 1 kHz, DIN)
Continuous RMS power output (reference):
23 + 23 W
(6 ohms at 1 kHz, 10% THD)
Inputs
MD IN (phono jacks): Sensitivity 500 mV, impedance
47 kilohms
VIDEO IN (phono jacks): Sensitivity 250 mV, impedance
47 kilohms
MIC (phone jack): sensitivity 1 mV,
impedance 10 kilohms
Outputs
LINE OUT (phono jacks): Sensitivity 250 mV, impedance
1 kilohm
OPTICAL DIGITAL OUT (CD):
Optical
VIDEO OUT (phono jack):
max. output level
1Vp-p, unbalanced, Sync negative,
load impedance 75 ohms
PHONES (stereo phone jack):
Accepts headphones with an
impedance of 8 ohms or more
VIDEO CD/CD player section
System Compact disc and digital audio and
video system
Laser Semiconductor laser
(λ=780nm)
Emission duration: continuous
Max. 44.6 µ W*
Laser output
Wavelength 780 – 790 nm
Video color system format NTSC, PAL
CD DIGITAL OUT OPTICAL
(Square optical connector jack, rear panel)
Wavelength 660 nm
Output Level –18 dBm
* This output is the value
measured at a distance of
200 mm from the objective
lens surface on the Optical
Pick-up Block with 7 mm
aperture.