Checking The Final Gear Oil Level; Changing The Final Gear Oil - Yamaha FJR1300A(D) Service Manual

• If coolant is swallowed, induce vomiting
and get immediate medical attention.
ECA13480
NOTICE
• Adding water instead of coolant lowers the
antifreeze content of the coolant. If water is
used instead of coolant check, and if nec-
essary, correct the antifreeze concentra-
tion of the coolant.
• Use only distilled water. However, if dis-
tilled water is not available, soft water may
be used.
• If coolant comes into contact with painted
surfaces, immediately wash them with wa-
ter.
• Do not mix different types of antifreeze.
12.Install:
• Radiator cap
13.Fill:
• Coolant reservoir
(with the recommended coolant to the maxi-
mum level mark "a")
14.Install:
• Coolant reservoir cap
15.Start the engine, warm it up for several min-
utes, and then stop it.
16.Check:
• Coolant level
Refer to "CHECKING THE COOLANT LEV-
EL" on page 3-26.
TIP
Before checking the coolant level, wait a few
minutes until the coolant has settled.
17.Install:
• Side cowlings
Refer to "GENERAL CHASSIS" on page 4-1.
EAS21460

CHECKING THE FINAL GEAR OIL LEVEL

1. Stand the vehicle on a level surface.
TIP
• Place the vehicle on the centerstand.
• Make sure the vehicle is upright.
2. Remove:
• Final gear oil filler bolt "1"
3. Check:
• Final gear oil level
4. Install:
• Final gear oil filler bolt
a
EAS21470

CHANGING THE FINAL GEAR OIL

1. Place a container under the final gear case.
2. Remove:
• Final gear oil filler bolt "1"
• Final gear oil drain bolt "2"
3-29
PERIODIC MAINTENANCE
(along with the gasket "2")
The final gear oil level should be to the bot-
tom brim "3" of the filler hole.
Below the bottom brim → Add the recom-
mended final gear oil to the proper level.
1
3
2
Type
Shaft drive gear oil (Part No.:
9079E-SH002-00)
(along with the gasket
Final gear oil filler bolt
23 Nm (2.3 m·kg, 17 ft·lb)
(along with the gasket)
(along with the gasket)
Completely drain the final gear case of its oil.
New )