Checks After Starting Engine; Cooling Water - Yamaha F75B Owner's Manual

2. Attach the engine shut-off cord to a se-
cure place on your clothing, or your arm
or leg. Then install the clip on the other
end of the cord into the engine shut-off
switch.
3. Turn the main switch to "
TIP:
Dual engine users: When the main switch is
turned on, the buzzer operates for a few sec-
onds then stops automatically. The buzzer
also operates if one of the engines stalls.
4.
5.
" (on).
EMU36510

Checks after starting engine

EMU36520

Cooling water

Check for a steady flow of water from the cool-
ing water pilot hole. A continuous flow of water
from the pilot hole shows that the water pump
is pumping water through the cooling passag-
es. If the cooling passages are frozen, it may
take a while for water to start flowing out of the
pilot hole.
Turn the main switch to "
and hold it for a maximum of 5 seconds.
ON
OFF
Immediately after the engine starts, re-
lease the main switch to return it to "
(on). NOTICE: Never turn the main
switch to " " (start) while the en-
gine is running. Do not keep the start-
er motor turning for more than 5
seconds. If the starter motor is turned
continuously for more than 5 sec-
onds, the battery will be quickly dis-
charged, thus making it impossible to
start the engine. The starter can also
be damaged. If the engine will not start
after 5 seconds of cranking, return the
main switch to "
onds, then crank the engine again.
[ECM00192]
Operation
" (start),
START
ZMU01881
" (on), wait 10 sec-
45
"