Operation - Makita GD0800C Instruction Manual

Installing the side handle
Always use the side handle to ensure oper-
ating safety.
Install the side handle on the tool barrel,
then tighten the handle by turning clock-
wise at the desired position.
~
OPERATION
Turn the tool on without the wheel point
making any contact with the workpiece and
wait until the wheel point attains full speed.
Then apply the wheel point to the work-
piece gently. To obtain a good finish, move
the tool in the leftward direction slowly.
CAUTION:
Apply light pressure on the tool. Excessive pressure on the tool will only cause a poor
finish and overloading of the motor.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and unplugged before attempting to perform
inspection or maintenance.
To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspection and re-
placement, any other maintenance or adjustment should be performed by Makita
Authorized or Factory Service Centers, always using Makita replacement parts.
8