Operation - Makita DTW250 Instruction Manual

ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Selecting correct socket
Always use the correct size socket for bolts and nuts. An
incorrect size socket will result in inaccurate and
inconsistent fastening torque and/or damage to the bolt
or nut.
Installing or removing socket
Fig.6
1. For socket without O-ring and pin
To install the socket, push it onto the anvil of the
tool until it locks into place.
To remove the socket, simply pull it off.
2. For socket with O-ring and pin
Fig.7
Move the O-ring out of the groove in the socket and
remove the pin from the socket. Fit the socket onto
the anvil of the tool so that the hole in the socket is
aligned with the hole in the anvil. Insert the pin
through the hole in the socket and anvil. Then return
the O-ring to the original position in the socket
groove to retain the pin. To remove the socket,
follow the installation procedures in reverse.
Hook
Fig.8
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.

OPERATION

CAUTION:
Always insert the battery cartridge all the way until
•
it locks in place. If you can see the red part on the
upper side of the button, it is not locked completely.
Insert it fully until the red part cannot be seen. If not,
it may accidentally fall out of the tool, causing injury
to you or someone around you.
Hold the tool firmly and place the socket over the bolt or
nut. Turn the tool on and fasten for the proper fastening
time.
Fig.9
The proper fastening torque may differ depending upon
the kind or size of the bolt, the material of the workpiece
to be fastened, etc. The relation between fastening
torque and fastening time is shown in the figures.
Standard bolt
N m
(kgf cm)
160
(1,632)
140
(1,428)
120
(1,224)
100
M14
(1,020)
80
M12
(816)
60
(612)
40
(408)
20
(204)
0
1.0
0 0.5
Fastening time (S)
007536
High tensile bolt
N m
(kgf cm)
200(2,040)
180(1,836)
160(1,632)
140(1,428)
120(1,224)
100(1,020)
80(816)
60(612)
40(408)
20(204)
0
1.0
Fastening time (S)
007535
NOTE:
Hold the tool pointed straight at the bolt or nut.
•
Excessive fastening torque may damage the
•
bolt/nut or socket. Before starting your job, always
perform a test operation to determine the proper
fastening time for your bolt or nut.
If the tool is operated continuously until the battery
•
cartridge has discharged, allow the tool to rest for
15 minutes before proceeding with a fresh battery
cartridge.
The fastening torque is affected by a wide variety of
factors including the following. After fastening, always
check the torque with a torque wrench.
1. When the battery cartridge is discharged almost
completely, voltage will drop and the fastening
torque will be reduced.
2. Socket
Failure to use the correct size socket will
•
cause a reduction in the fastening torque.
A worn socket (wear on the hex end or square
•
end) will cause a reduction in the fastening
torque.
6
M16
M16
M14
M12
2.0
1.5
M14
M14
M12
M10
M12
M10
2.0 3.0