Hitachi FP-Z31 Operation Manual page 13

adaptor,
battery
adaptor
@ POWER
. ,/
connector
t ·,
r
t
t
I·
�·
@CAM OUT--
connector
@
MIC connector
Align the plug on the MC-30E microphone con­
nector with the connector's guide key position and
insert.
@
Microphone cable clamp
To attach the microphone, push the microphone
cable into this clamp and secure.
@
4.5-inch viewfinder mounting shoe
When the 4.5-inch viewfinder is to be used in place
of the 1.5-inch viewfinder, insert the GM-5 4.5-
inch viewfinder into this mounting shoe using the
AT-21 viewfinder adaptor and secure. The view­
finder cable connector is then connected to the
viewfinder connector
Refer to section 6.1.4(2) for details on how to
attach the 4.5-inch viewfinder.
@
Mounting
trol adaptor, battery adaptor
In systems employing a remote operation panel or
a digital command unit, the mounting screws of the
.-
. •: ..
@4.5-inch viewfinder
mounting shoe
@Remote
control
adaptor
connector
cover
Rear view
@POWER
@VTR
switch connector
1
··
-:.J�_P"�
•. QN
our .
connector
Fig. 5.5
@ ;
screw holes for remote con­
�
. . :
}
RA-231 remote control adaptor are inserted into
these holes, and the screws are tightened to secure
the adaptor. The BA-31 battery adaptor can be
mounted when the camera is being used for
portable applications.
@
Remote control adaptor connector cover
[PUSH OPEN]
When attaching the RA-231
@ ,
adaptor using the holes
center of this cover, slide it toward the left to
open it. The connector for the RA-231 adaptor
will then be accessible. To mount the RA-231,
insert the RA-231 's connector into th is connector
and .then tighten up scre f S to secure.
@
POWER connector
The plug on an external power supply, such
as the PB-20A battery belt, the AP-40 AC adaptor
or the BX-31 battery pack, is connected to this
connector.
(l§)
POWER · s witch [POWER, POWER/ROU/
VTR]
When this switch is set, the camera is set to the
standby mode and POWER indicator
To supply power from the POWER connector
@ ,
set the switch to POWER (left-hand posi­
tion); to supply power from the VTR connector
@ ,
set to VTR (right-hand position); and to
supply power from the remote operation panel,
set to ROU (center position). With these setting�,
power is supplied to the heaters of the pickup
tubes and to the zoom ter1s. Set this switch to off
(position where power is not supplied), therefore,
when the camera is not to be used immediately
when power is being supplied from a battery.
@
VTR connector
When using a VTR, connect a specified VTR cable
to this connector.
@
Fuse holder [5A]
A fuse (5A) has been placed in the power input
line.
When the fuse has blown, first find out what
caused it to blow and then replace it with the
supplied fuse.
(Do not use any fuses other than the same kind as
those supplied.)
@
CAM_
0 UT connector
The color composite signal from the camera is fed
out here ( 1 Vp-p, 75 ohms).
.;.
•.·
.;�!:.: .. _ .. :._ .. ··-· -
remote control
push I ightly on the
(J)
lights.
11