Hitachi FP-Z31 Operation Manual page 12

;,_._._
.
.
•
� , i
(2) Status display
(3) Title character setting display
The title characters (3) are output to CAM OUT in
addition to the viewfinder and MON OUT.
When this switch is set to the WRITE position,
characters can be selected and written. The charac­
ters which have been written are retained in the
memory.
1.
CURSOR switch
This switch determines where on the screen
'!i·
the characters should be written. When it is
set to the
from the top left to the right; when set to
the � position, it moves in the reverse
direction. For further details, refer 'to sec­
tions 6.3.1 to 6.3.3.
Note: This switch does not function on the
FP-Z31 L.
@
MIC connector
@
Microphone
cable clamp
@
Front view
10
....
• .. .
\:
:::.·. ;: ::\{
..
.·.
.
� position, the cursor moves
Right side view
4.5-inch
viewfinder
mounting shoe
1.5-inch
viewfinder
mounting seat
LENS
connector
@
Tripod adaptor
mounting fixture
Fig. 5.4
@
Tally indicators
These indicators light in accordance with the
external tally signals when the camera is being ope­
rated in a system employing a remote operation
panel or when the VTR is set to the recording
mode. They also light when the CALL button has
been depressed for a call from the remote opera-
tion panel.
@
1.5-inch viewfinder mounting seat
The fixture for the 1.5-inch viewfinder, GM-3B is
slotted into the grooves and slid to the left or right
onto this mounting seat. It is then secured with
the screws on the fixture. For further details, refer
to section 6.1.4( 1).
@
Viewf ! n'der connector
The viewfinder cable connector is inserted in the
direction in which the guide key fits; the con­
nector's locking ring is then rotated clockwise to
lock the connector.
Note: It is not possible to use the 1.5-inch and
4.5-inch viewfinders at the same time.
@
Lens clamp lever
To mount the lens onto the camera, the lens is
: mp�nt�d with the lens clamp lever at a position
approximately 20 degrees higher than the position
shown in Fig. 5.4 and the lever is then rotated
clockwise to clamp the lens. When mounting the
lens, align the position of the lens guide key with
the bayonet mount.
Securely hold the lens so that it will not drop
when operating this lever to·cemove the lens.
@
LE NS connector
The cable plug of the zoom lens is aligned with
this connector and the guide key and inserted.
By the connection, the auto iris and power zoom
operations are enabled. When the connector is to
be disconnected, grasp the locking ring on the
connector, pull it toward you to release the lock
and then unplug the connector. Do not tug on the
cable itself to unplug the connector.
®
Tripod adaptor mounting fixture
Refer to section 6.1.3 for details on h OV'I to
attach the-camera to the tripod adaptor.
@
Microphone mounting shoe
Insert the MC-30E microphone mounting foot into
this shoe.
'•' >:-·'.. .: :-
.
·.:..:.. _'\.·.l' '_.;:- .;-· .
; · �
t l
; :_.
. .I
t
@
I
Alig
nect
inse
//�
@
Toi
cabl1
@
Whei
of t
inch
AT-:
findt
view
Refe
atta<
@
In s•
a di!