Functional Description; Switch Action; Reversing Switch Action; Speed Change - Makita DP4010 Instruction Manual

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.

Switch action

4
5
3
2
002990
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and returns
to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Tool speed
is increased by increasing pressure on the switch trigger.
Release the switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
A speed control screw is provided so that maximum tool
speed can be limited (variable). Turn the speed control
screw clockwise for higher speed, and counterclockwise
for lower speed.

Reversing switch action

A
B
1
002991
This tool has a reversing switch to change the direction of
rotation. Move the reversing switch lever to the
(A side) for clockwise rotation or the
for counterclockwise rotation.
CAUTION:
Always check the direction of rotation before operation.
•
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
1. Lock button
1
2. Speed control
screw
3. Switch trigger
4. Higher
5. Lower
1. Reversing switch
lever
position (B side)

Speed change

1
2
002691
Two speed ranges can be preselected with the speed
change knob.
To change the speed, turn the speed change knob so that the
arrow on the tool body points toward the "I" position on the
knob for low speed or "II" position for high speed.
If it is hard to turn the knob, first turn the chuck slightly in
either direction and then turn the knob again.
CAUTION:
Use the speed change knob only after the tool
•
comes to a complete stop. Changing the tool speed
before the tool stops may damage the tool.
Always set the speed change knob to the correct
•
position. If you operate the tool with the speed
change knob positioned halfway between the "I"
and "II" position, the tool may be damaged.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing side grip (auxiliary handle)
1
2
002693
Always use the side grip to ensure operating safety.
Install the side grip so that the teeth on the grip fit in
position
between the protrusions on the tool barrel.
Then tighten the grip by turning clockwise at the desired
position.
NOTE:
The depth gauge cannot be used at the position
•
where the depth gauge strikes against the gear
housing.
5
1. Arrow
2. Speed change
1. Grip base
3
2. Side grip
(auxiliary
handle)
3. Teeth
4. Protrusions
4
knob