Configure Wpa/Wpa2 Personal - D-Link DHP-W307AV User Manual

Section 3 - Configuration
It is recommended to enable encryption on your wireless access point before your wireless network adapters. Please establish wireless connectivity
before enabling encryption. Your wireless signal may degrade when enabling encryption due to the added overhead.
1. Log into the web-based configuration by opening a web browser and entering the IP address of the access point (192.168.0.50). Click on Setup
and then click Wireless.Settings on the left side.
2. For Security Mode, select WPA.Personal.
3. For WPA Mode, you can select Auto.(WPA.or.WPA2), WPA2.only.
or WPA.Only.
4. For Cipher Type, select TKIP.and.AES or TKIP or AES.
5. For Pre-Shared Key, enter a key. The Pre-Shared Key must be
between 8-63 characters.
6. Click Save Settings at the top of the window to save your settings.
If you are configuring the access point with a wireless adapter, you
will lose connectivity until you enable WPA-PSK on your adapter
and enter the same passphrase as you did on the access point.
D-Link DHP-W307AV User Manual

Configure WPA/WPA2 Personal

53