Rear Fender; Grab Rail - Honda 1998 VT750C Service Manual

FRAME/BODY PANELS/EXHAUST SYSTEM
REAR FENDER
REMOVAL
NOTE:
Be careful not to scratch the fender or deform the
connector stay.
Remove the front and rear seat (page 2-2).
Remove the right side cover (page 2-4).
Disconnect the tail/brake light connectors inside the
connector boot.
Remove the bolts, washers and the rear fender.
Installation is in the reverse order of removal.
TORQUE: 26 N'm (2.7 kgf'm, 20 Ibf·ft)
REAR FENDER
BOLTS
GRAB RAIL
WASHER
BOLT
NOTE:
The rear fender must be removed from the frame
before servicing the each side grab rails.
LEFT SIDE
Loosen the left grab rail mounting nut located on
the left shock absorber mounting bolt.
Remove the bolt, washer and left grab rail.
RIGHT SIDE
Remove the right side shock absorber (page 14-18).
Remove the 10 mm bolt, washer, 14 mm bolt and
right grab rail.
Installation is in the reverse order of removal.
TORQUE: 10 mm bolt: 64 N'm (6.5 kgf.m, 47 Ibf·ft)
24 mm nut: 88 N'm (9.0 kgf'm, 65 Ibf·ft)
14 mm bolt: 108 N'm (11.0 kgf'm, 80 Ibf·ft)
2-6
14 mm BOLT