Removing And Replacing The Hard Drive Scsi Backplane; Removing The Hard Drive Scsi Backplane - HP Integrity rx2620 User's & Service Manual

Figure 76 Securing the Power Supply Interface Module and Cables
3. Replace the system board.
4. Replace the power supply (or supplies).
5. Replace the top metal cover, and reconnect all of the power and external cables.
6. Verify the PSI replacement by using the utilities identified in
To verify operation, use the iLO MP commands.

Removing and Replacing the Hard Drive SCSI Backplane

Removing the Hard Drive SCSI Backplane

1. Power off the server, disconnect all power and external cables, and remove the
top metal cover.
2. Lift up on the PCI cage release lever and the back edge of the PCI cage and lift
the PCI cage out of the server.
3. Lift up on the fan power bridge and disconnect the backplane power cable. See
Figure 77.
Appendix C (page 134).
79