Removing And Replacing An Internal Hard Drive; Removing A Hard Drive - HP Integrity rx2620 User's & Service Manual

Figure 28 Replacing the Power Supply
4. Verify that both power supply LEDs, visible through the front of the supply grid,
are illuminated.
5. Verify the power supply replacement by using the utilities identified in
(page 134).
6. To verify power supply operation, use the iLO MP PS command.
7. Replace the front bezel.

Removing and Replacing an Internal Hard Drive

This section provides information about removing and replacing internal hard drives.
The server supports up to three hot-pluggable, low-voltage differential (LVD) hard
drives. These hard drives are 3.5-inch form factor devices that connect to Ultra 320
Wide LVD SCSI interfaces on the disk cage backplane.
CAUTION:
the operating system is running. If the operating system does not support this feature,
shut down the operating system before attempting this procedure. Failure to observe
this caution results in server failure.

Removing a Hard Drive

To remove a hard drive:
1. If the server is powered on and the operating system is running, prepare the
operating system to have the hard drive removed. Shut down your operating
system by following your operating system instructions.
2. If you have not locked your hard drives, proceed to step
your hard drives, you must unlock them before removing or replacing a drive:
a. Remove the top metal cover. See
CAUTION:
server, you will damage the hard drive bay.
Verify that the operating system supports installing disk drives while
If you try to remove a hard drive without unlocking it from the
Step
"Removing the Top Metal Cover" (page
Appendix C
3. If you have locked
33).
40