Zanussi zfx405w User Manual page 17

Problem
There is too much frost and ice
It is too warm in the freezer
It is too cold inside the freezer
The appliance does not work at
all.
Closing the door
1. Clean the door gaskets.
Possible cause
Doors are not shut properly or do not
close tightly
The door has been opened too fre-
quently
Large quantities of food to be frozen
were put in at the same time
Food placed in the appliance was too
warm
The room temperature is too high.
Products are not wrapped properly
Doors are not shut properly or do not
close tightly
The Temperature regulator may be set
incorrectly
Temperature regulator may be set in-
correctly
The door does not close tightly or it is
not shut properly
Large quantities of food to be frozen
were put in at the same time
Food placed in the appliance was too
warm
Products to be frozen are placed too
closely to each other
Temperature regulator may be set in-
correctly
Plug is not connected to the mains
socket properly
Power does not reach the appliance
The appliance is not switched on
There is no voltage in the mains sock-
et (try to connect another appliance in-
to it)
Plug is not connected to the mains
socket properly
Check if the doors close well and the
gaskets are undamaged and clean
Do not leave the door open longer than
necessary
Wait some hours and then check the
temperature again
Allow food to cool to room temperature
before storing
Decrease the room temperature.
Wrap the products better
Check if the doors close well and the
gaskets are undamaged and clean
Set a warmer temperature
Set a lower temperature
Check if the door closes well and the
gasket is undamaged and clean
Insert smaller quantities of food to be
frozen at any one time.
Allow food to cool to room temperature
before storing.
Place the products in a way so that cold
air could circulate among them
Set a warmer temperature
Connect the mains plug properly
Try connecting another electrical device
to the power outlet
Switch on the appliance
Call an electrician
Connect the mains plug properly
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets.
Contact the Service Center.
Solution
17