Breville HotCup VKJ367 Manual page 6

PREPARING THE BRITA
1. Remove the cartridge from its wrapping (it is normal for the
cartridge to appear moist during storage).
2. Immerse the cartridge in cold tap water and shake gently to
remove any air bubbles. There is no need to pre-soak this
cartridge before use.
3. Lift the complete lid off your HotCup
funnel. Insert the cartridge into the filter funnel and push it
firmly into place. When correctly fitted, the cartridge should
remain in place when the funnel is turned upside-down.
4. Fill the filter funnel with cold tap water up to the MAX mark
and allow it to filter through discarding the water. Repeat
this process, again discarding the water.
5. The BRITA MAXTRA
®
do not need to keep the filter cartridge immersed in water.
Refit the filter funnel and filter into your HotCup
the lid.
6. Always make sure that you have spare MAXTRA
cartridges to hand. When buying new cartridges look for
the BRITA MAXTRA
®
7. When it is time to replace the BRITA
cartridge after 4 weeks use, simply lift the handle on top
of the cartridge and pull upwards to remove. BRITA
cartridges are 100% recyclable. Visit www.brita.co.uk or
call the BRITA
®
information on participating retailers.
8. Repeat steps 1-5 with a new cartridge.
6
MAXTRA
®
cartridge is now ready for use. You
®
logo on the cartridge packaging.
®
Care team on 0844 742 4800 for further
CARTRIDGE
®
and remove the filter
™
. Replace
™
®
MAXTRA filter
® ®
®