Table of Contents
Advertisement
Reference Manual for the 54 Mbps Wireless Router WGR614 v4
•
Disable. No encryption will be applied. This setting is useful for troubleshooting your wireless
connection, but leaves your wireless data fully exposed.
•
64-bit or 128-bit WEP. When 64-bit or 128-bit is selected, WEP encryption will be applied.
If WEP is enabled, you can manually or automatically program the four data encryption keys.
These values must be identical on all PCs and access points in your network.
There are two methods for creating WEP encryption keys:
•
Passphrase. Enter a word or group of printable characters in the Passphrase box and click the
Generate button. These characters are case sensitive.
•
Manual. For 64-bit WEP, enter 10 hexadecimal digits (any combination of 0-9, a-f, or A-F).
For 128-bit WEP, enter 26 hexadecimal digits (any combination of 0-9, a-f, or A-F). These
values are not case sensitive.
Default Factory Settings
When you first receive your WGR614 v4, the default factory settings are shown below. You can
restore these defaults with the Factory Default Restore button on the rear panel. After you install
the WGR614 v4 router, use the procedures below to customize any of the settings to better meet
your networking needs.
Wireless Access Point
Wireless Access List (MAC Filtering)
SSID broadcast
11b/g RF Channel
Authentication Type
3-6
FEATURE
DEFAULT FACTORY SETTINGS
Enabled
All wireless stations allowed
Enabled
SSID
NETGEAR
11
Mode
g and b
Open System
WEP
Disabled
December 2003
Wireless Configuration
Advertisement
Table of Contents
Troubleshooting
