Default Factory Settings - NETGEAR RangeMax Next Wireless Router WNR834M Reference Manual

NETGEAR RangeMax™ NEXT Wireless Router WNR834M Reference Manual
Key 3: ___________________________________
Key 4: ___________________________________
• If WPA-PSK or WPA2-PSK Authentication is Used:
– Passphrase: ______________________________ These characters are case sensitive.
Enter a word or group of printable characters. When you use WPA-PSK, the other devices
in the network will not connect unless they are set to WPA-PSK as well and are configured
with the correct Passphrase. Similarly, when you use WPA2-PSK, the other devices in the
network will not connect unless they are also set to WPA2-PSK and are configured with
the correct Passphrase.
Use the procedures described in the following sections to configure the WNR834M. Store this
information in a safe place.

Default Factory Settings

When you first receive your WNR834M, the default factory settings are in effect, as shown below.
You can restore these defaults with the Factory Default Restore button on the rear panel. After you
install the WNR834M router, use the procedures below to customize any of the settings to better
meet your networking needs.
Wireless Access List (MAC Filtering)
3-4
FEATURE
Wireless Router Radio
SSID broadcast
SSID
802.11b/g RF Channel
Mode
Security
v1.3, May 2006
DEFAULT FACTORY SETTINGS
Enabled
All wireless stations allowed
Enabled
NETGEAR
Auto
Up to 300 Mbps
None
Wireless Configuration