How To Configure Wep Encryption Security - NETGEAR WG311 Installation Manual

Installation Guide for the NETGEAR 54 Mbps Wireless PCI Adapter WG311

How to Configure WEP Encryption Security

Following the steps below to configure WEP Encryption Security.
1. Run the WG311 Configuration Utility.
Open the configuration utility by clicking on the WG311 icon
a.
system tray.
Figure 3-5: Settings tab page
Click on the Settings tab to display the view shown above.
b.
2. Configure the Security settings.
Select the Use WEP Encryption check box.
a.
Enter the SSID. This is also called the Wireless Network Name.
b.
Note: You will not get a wireless network connection unless the network SSID matches
exactly what is configured in the access point.
3-10
in the Windows
Configuration