NETGEAR WG111 User Manual page 18

User Manual for the NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG111
Table 2-1. A Road Map for How to Get There From Here
If I Want To? What Do I Do?
Connect to the
1. Activate my
Internet over my
wireless link and
wireless
verify my network
network.
connection.
2. Open an Internet
browser such as
Internet Explorer
or Netscape
Navigator.
2-4
What's Needed?
1. An active Internet
connection like those from
cable or DSL service
providers.
2. A wireless network
connected to the cable or
DSL Internet service
through a cable/DSL
router as illustrated in
"Connecting to an Access
Point in Infrastructure
Mode" on page 4-2.
3. TCP/IP Internet
networking software
installed and configured
on my PC according to the
requirements of the
Internet service provider.
4. A browser like Internet
Explorer or Netscape
Navigator.
202-10026-01
How Do I?
To configure your WG111 in
Infrastructure Mode, see
Installation Instructions" on
page 3-4, and locate the section
for your version of Windows.
For assistance with configuring
the TCP/IP Internet software on
a PC, see "Preparing Your
Computers for TCP/IP
Networking" on page C-1
to the PC Networking Tutorial on
the NETGEAR 54 Mbps
Wireless USB 2.0 Adapter
WG111 Resource CD
(230-10044-01) and the Help
information provided in the
Windows system you are using.
.
Introduction
"Basic
or refer