Registering Your Handset - NETGEAR SPH200D User Manual

Cordless Internet Phone with Skype Model SPH200D User Manual
• Reset All. Reset all the settings including the network settings.
• Keep Network. Reset all the settings except the network settings.
3. Enter the system PIN. Press Clear to make corrections.
4. Press Yes to confirm.
5. The settings will reset.
seconds after updating all the settings.

Registering Your Handset

Registration lets your base unit and handsets communicate. Your handset must be linked to the
base in order to make calls and to use many of features on the phone.
Your handset is already registered unless you have bought an extra handset individually, or you
have de-registered a handset. For additional handsets, see
Additional Base" on page
Note: Your base unit can register up to four handsets. After registering four handsets,
your base unit registration memory is full. If you try to register an additional
handset, the registration process will not complete.
Follow the steps below to register your handset.
1. Press Menu>Settings>Handset>Register.
2. Enter the system PIN (Default: 0000). Press Clear to make corrections.
3. Press Enter to confirm. Your handset starts searching for the base.
4. Press on the base unit until the LED starts flashing.
5. The handset registers to the particular base unit, and shows the signal icon
7-4
Y
our handset's power switches off. It will switch back on in a few
7-5. If the handset is not registered, it displays "Unregistered."
v1.0, November 2006
"Registering Your Handset(s) with an
Settings and Maintenance
.