Linking To The Base Unit - NETGEAR SPH200D User Manual

Cordless Internet Phone with Skype Model SPH200D User Manual

Linking to the Base Unit

The signal icon on the handset shows the link status between your handset and the base unit.
Note: If your handset does not link, you will cannot make or receive any calls; and you
will not be able to use many of the phone features.
• Link icon. Your handset and base unit are linked. They can communicate.
• Lost Link icon
Make sure that the base unit is plugged in. Take your handset closer to the base unit to
reconnect the link.
• Unregistered. This handset is not registered to the base unit. It may have been purchased
separately. You must register the handset before it can link to the base unit. See
Your Handset" in Chapter
If you move too far away from the base unit while you are on the phone, you will hear warning
tones notifying you that your handset is almost out of range (the link is lost). Take your handset
closer to the base unit or your call will be cut off shortly after the warning.
2-6
. Your handset is not linked to the base unit. They cannot communicate.
7.
v1.0, November 2006
"Registering
Installation