Advertisement
Available languages
Available languages
ENGLISH
3-1. Pneumatic tool oil
4-1. Nose piece storing portion
5-1. Contact arm
5-2. Nose adapter
6-1. Adjuster
7-1. Latch lever
7-2. Door
7-3. Magazine cap
8-1. Magazine scale
SPECIFICATIONS
Dimensions (L X H X W)
Min. hose diameter
Pneumatic tool oil
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
Wear safety glasses.
Intended use
The tool is intended for the preliminary interior work such
as fixing floor joists or common rafters and framing work
in 2 "x 4" housing.
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 87 dB (A)
sound power level: 100 dB (A).
Wear ear protection.
The typical weighted root mean square acceleration
2
value is 8 m/s
.
These values have been obtained according to EN792.
EC-DECLARATION OF CONFORMITY
Model; AN901
We declare under our sole responsibility that this
product is in compliance with the following standards of
standardized documents;
EN792 in accordance with Council Directives, 98/37/EC.
Explanation of general view
8-2. Coil support plate
9-1. Slot
9-2. Feeder body
10-1. Air fitting
10-2. Air socket
13-1. Continuous nailing
13-2. Intermittent nailing
13-3. Change lever
13-4. Trigger lock
Model
Air pressure
Nail length
Nail capacity
Net weight
CE2008
END105-1
000230
Responsible Manufacturer:
Makita Corporation
3-11-8, Sumiyoshi-cho, Anjo, Aichi, JAPAN
Authorized Representative in Europe:
ENE059-1
Makita International Europe Ltd.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
ENG046-1
IMPORTANT SAFETY
INSTRUCTIONS
WARNING: WHEN USING THIS TOOL, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED TO REDUCE THE RISK OF PERSONAL
INJURY, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS.
For personal safety and proper operation and
ENH013-7
•
maintenance of the tool, read this instruction
manual before using the tool.
Always wear safety glasses to protect your eyes
•
from dust or nail injury.
WARNING:
It is an employer's responsibility to enforce the use
of safety eye protection equipment by the tool
operators and by other persons in the immediate
4
14-1. Small rod
14-2. Ejection port
15-1. Hook
19-1. Change lever
19-2. Trigger lock
22-1. Drain cock
23-1. Air filter
24-1. Oiler
24-2. Pneumatic oil
AN901
0.44 - 0.83 Mpa ( 4.4 - 8.3 bar)
45 mm - 90 mm
150 - 300 pcs.
408 mm X 316 mm X 131 mm
8.5 mm
Turbine oil
3.1 Kg
Tomoyasu Kato
Director
ENB067-2
Advertisement
