Makita BUK360 Instruction Manual page 6

Overloaded:
•
The tool is operated in a manner that causes
it to draw an abnormally high current.
In this situation, release the switch trigger on
the tool and stop the application that caused
the tool to become overloaded. Then pull the
switch trigger again to restart.
If the tool does not start, the battery is
overheated. In this situation, let the battery
cool before pulling the switch trigger again.
Low battery voltage:
•
The remaining battery capacity is too low and
the tool will not operate. In this situation,
remove and recharge the battery.
Battery remaining capacity indicator
(only for models with Battery BL3622A)
Battery BL3622A is equipped with the battery remaining
capacity indicator.
1
2
011715
Press the CHECK button to indicate the battery
remaining capacity. The indicator lamps will then light for
approx. three seconds.
Indicator lamps
Lighted Off Blinking
E
011713
When only the lowermost indicator lamp (next to the
•
"E") blinks, or when none of the indicator lamps light,
the battery capacity has run out, so the tool does not
operate. In these cases, charge the battery or
replace the empty battery with a fully charged one.
When two or more indicator lamps do not light even
•
after charging is complete, the battery has reached
the end of its service life.
1. Indicator lamps
2. CHECK button
Remaining capacity
70% to 100%
F
45% to 70%
20% to 45%
0% to 20%
Charge the battery.
The battery may have
malfunctioned.
When the upper two and lower two indicator lamps
•
light alternately,
malfunctioned.
authorized service center.
NOTE:
The indicated capacity may be lower than the actual
•
level during use or immediately after using the tool.
Depending on the conditions of use and the
•
ambient temperature, the indication may differ
slightly from the actual capacity.
Battery converters (optional accessory)
WARNING:
Before installing or removing the battery converters
•
BCV01/BCV03, remove the lock key.
BCV01 (optional accessory)
WARNING:
When using the BCV01, be sure to use the holder
•
(optional accessory) to retain its cord. Failure to use
the holder leaves the cord loose. This may cause
the cord to be entangled by the blade, resulting in
damage to the tool and a personal serious injury.
When using the BCV01, never attach it to any part
•
of your body. Attaching the BCV01 to any part of
your body may cause a serious injury.
2
1. Battery converter (BCV01)
2. Installation hole
012932
Hook the battery converter BCV01 onto installation
section of the handle.
Holder (optional accessory)
When using the BCV01, be sure to use the holder
(optional accessory) to retain its cord.
6
the battery may
Contact your local
have
Makita
1