Parts Description; Functional Description; Installing Or Removing Battery Cartridge - Makita BUK360 Instruction Manual

PARTS DESCRIPTION

3
4
012872

FUNCTIONAL DESCRIPTION

Installing or removing battery cartridge

012870
012840
CAUTION:
Always switch off the tool before installing or
•
removing of the battery cartridge.
Hold the battery cartridge firmly with both
•
hands when installing or removing battery
cartridge. Failure to hold the battery cartridge
firmly may cause it to slip off your hands and result
in damage to the tool and battery cartridge and a
personal injury.
2
1
1. Button
2. Red indicator
3. Battery cartridge
2
3
1
1. Button
2. Red indicator
3. Battery cartridge
2
3
1 Grip
2 Battery hood
3 Front carry handle
6
4 Cultivator blade
5 Transport wheel
6 Rear carry handle
5
Be careful not to have your thumb and fingers
•
pinched when closing the battery hood.
Unfasten the buckle on the both side of the tool, and
open the battery hood.
To remove the battery cartridge, slide it from the tool
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip it
into place. Insert it all the way until it locks in place with a
little click. If you can see the red indicator on the upper
side of the button, it is not locked completely.
Close the battery hood, and fasten the buckle.
This tool can equip up to two battery cartridges. You can
install one or two batteries. The battery can be installed
on either side of the slot.
CAUTION:
Do not install the battery cartridge forcibly. If the
•
cartridge does not slide in easily, it is not being
inserted correctly.
NOTE:
If you install two batteries, you can choose which battery
you are going to use by flipping the battery selector
switch.
Battery protection system
Lithium-ion batteries are equipped with a protection
system. This system automatically cuts off power to the
tool to extend battery life.
The tool will automatically stop during operation if the tool
and/or battery are placed under one of the following
conditions:
5
1