Connecting To A Remote Access Server - NEC MobilePro 790 User Manual

Select Dial-Up Connection as the connection type and tap Next.
4.
Use the drop-down box to select Internal Modem on COM 4 and tap
5.
Configure.
Select the required port settings and call options. Tap OK.
6.
Tap TCP/IP Settings and configure the required General Settings and
7.
Name Servers. Tap OK.
Tap Next and enter the required dial-up telephone number. Tap
8.
Finish.
Once your ISP connection is established you can configure your
MobilePro to send and receive email through your ISP. Follow the
instructions in "Sending and Receiving Email" and "Activating a
Connection," later in this chapter, to send and receive email through your
ISP.
For ISP settings, access: http://www.cewindows.net/wce/isp.htm/.
Although not an official NEC web site, this site contains important
information about ISP settings.

Connecting to a Remote Access Server

Once you establish an account with your RAS and gather the necessary
configuration information, you are ready to create a connection on your
MobilePro for your RAS account.
Follow these steps to create a new connection for your RAS account.
Tap Start, Programs, Communication, then select Remote
1.
Networking.
Double tap the Make a New Connection icon.
2.
Enter a name for the new connection.
3.
Select Dial-Up Connection as the connection type and tap Next.
4.
Use the dropdown box to select Internal Modem on COM 4 and tap
5.
Configure.
Select the required port settings and call options. Tap OK.
6.
5-4 Setting Up a Remote Connection