Maytag MTW6500TB Service Manual page 57

6. At the right rear corner of the washer,
reach down and pull the pressure trans-
ducer tube off the tank.
Pressure Transducer Tube
7. Lower (do not latch) the top of the cabi-
net.
8. Carefully lay the washer on its front pan-
el. Place padding on the floor to protect
the surfaces.
9. Remove the drain and recirculation pumps
(see page 4-12 for the procedures).
10. Remove the drive motor (see page 4-14
for the procedure).
11. Pull the tub out of the bottom of the washer.
12. Remove the two 5/16˝ hex-head screws
from the counterbalance weight and re-
move the weight from the tub.
13. Loosen the clamps and remove the recir-
culation and drain hoses from the tub.
14. Remove the hex-head clamp screw from
the recirculation outlet hose extension,
and remove the extension from the side of
the tub.
Recirculation Outlet Hose Extension
Drain Hose
4-17
Washer Tub
Recirc. Hose
Counterbalance Weight