Maytag MTW6500TB Service Manual page 45

f) Loosen the clamps and remove the four
hoses going to the water inlet/dispenser
valve assembly.
Water Inlet/Dispenser Valve Hoses
g) Lower the cabinet top.
h) Slide the power supply cord strain relief
out of the housing and move it away from
the valve assembly.
i) Remove the two hex-head screws from
the water inlet/dispenser valve assem-
bly, and remove the assembly from the
washer.
Strain Relief
Screw
Water Inlet/Dispenser Valve Assembly
5.
Cord Strain Relief
6.
Screw
4-5
To remove the power supply cord:
a) Disconnect the power supply cord
connector from the machine/motor
control.
b) Remove the hex-head screw from the
green ground wire.
c) Slide the power supply cord strain re-
lief out of the housing and remove the
cord.
Power Supply
Ground Screw
To remove the machine/motor control
& pressure transducer:
a) Disconnect the nine wire connectors
from the control.
b) Pull the pressure transducer tube off
the fitting on the control.
c) Remove the hex-head mounting screw.
d) Lift the front of the control, slide it out
from under the clips at the back, and
remove it.
P2 P4 P13 P5
P1
Machine/Motor Control
Connector
P9 P10
P12 P11
Screw
Pressure Transducer
Tube