Pbx Configuration And Setup; Sip Trunk Configuration - Voice - Cisco SPA8000 Configuration Manual

| Cisco SPA8000 8-Port Telephony Gateway SIP Trunking Configuration Guide
4
6. Click on "Advanced" on the top right hand of the page. "Advanced should
turn back and "Basic" should turn blue.
7. Now to configure the SPA-8000 SIP trunk, Select the "Voice" tab on the top
of the screen and select the "T1" tab.

PBX CONFIGURATION AND SETUP

Two separate Intermedia SIP trunks were configured, one for voice with G729,
G711 and one for fax with G711 only. The SPA8000 was configured with 2
voice lines L1, L2 that work with the voice trunk T1. The fax trunk T2 is using
line L4.

SIP TRUNK CONFIGURATION - VOICE

Configure the Voice Trunk T1 with the Intermedia SIP Trunk credentials. Enter
the information as detailed below using your supplied Proxy Address and
username and password from Intermedia. The voice trunk will hunt across lines
1 and 2 in this example, enter hunt rules in the "Contact List" section.