Prerequisite For Configuring The Unit With Intermedia Sip Trunks - Cisco SPA8000 Configuration Manual

| Cisco SPA8000 8-Port Telephony Gateway SIP Trunking Configuration Guide
2
INTRODUCTION
These Notes describe the procedures for configuring Session Initiation Protocol
(SIP) Trunking between service provider Intermedia.net Inc. (Intermedia) and a
Cisco SPA8000 8 Port Analog Gateway. The Interop was performed with an
Iwatsu ADIX-VS Phone System (Analog PBX) as the analog end point to the
gateway. The Iwatsu ADIX-VS phone system is an analog PBX connecting with
RJ11 to the SPA8000. This Interop is not limited to this analog phone device.
The Intermedia SIP Trunking service referenced within these Notes is designed
for business customers. The service enables local and long distance PSTN
calling via standards-based SIP trunks directly as an alternative to legacy
analog or digital trunks, without the need for additional TDM enterprise
gateways and the associated maintenance costs.
PREREQUISITE FOR CONFIGURING CISCO SPA8000 WITH
INTERMEDIA SIP TRUNKS
Intermedia Configuration Information
You should have the configuration information from Intermedia before you start
the install. This information will provide settings for the SIP connection(s).
The information you will receive from Intermedia will be composed of the
following information. Your order will be different from this information:

Primary codec: G.729

Secondary codec: G.711
SIP TRUNK ID
PASSWORD
DNS NAME
IP ADDRESS
PORT 6060
Call processing has been setup to allow up to 2 simultaneous calls.
The following 911 callback number has been configured in our
network as the default for this location; please test and make sure you
are able to present this as the 911 callback number and program it to
route appropriately on inbound.
2065172775
This can also be used for testing inbound calls and has been setup as
the default for outbound CLI. The following additional test number has
also been provisioned.
2065172789
dgwsid10941
********
usbc.accessline.com
64.28.113.10