Installer Setup - Honeywell PRO TH3110D Installation Manual

Installation Guide

Installer setup

Follow the procedure below to configure the thermostat to match the
installed heating/cooling system, and customize feature operation as desired.
To begin, press and hold the
buttons until the display changes.
Setup function
1 System type
TH3110D only
5 Heating cycle rate
(CPH: cycles/hour)
TH3110D only
6 Auxiliary heat
cycle rate (CPH)
TH3210D only
8 Emergency heat
cycle rate (CPH)
TH3210D only
9 Compressor
cycle rate (CPH)
14 Temperature
display
15 Compressor
protection
69-1929EFS—01
Function
number
s t
and Press
Press
Press and hold
Settings & options (factory default in bold)
0 Gas, oil or electric heat with air conditioning
1 Heat pump (5 minute compressor off time in heating and
cooling)
5 For gas or oil furnaces of less than 90% efficiency
1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
9 For electric furnaces
[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]
5 For gas or oil furnaces of less than 90% efficiency
1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
9 For electric furnaces
[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]
9 For electric emergency heat
1 For steam or gravity systems
3 For hot water systems & furnaces of over 90% efficiency
5 For gas or oil furnaces of less than 90% efficiency
[Other cycle rate options: 2, 4, 6, 7, 8, 10, 11 or 12 CPH]
3 Recommended for most compressors
[Other cycle rate options: 1, 2, 4, 5, or 6 CPH]
0 Fahrenheit
1 Celsius
5 Five-minute compressor off time **See page 8
[Other options: 0, 1, 2, 3 or 4]
6
Setting
Setup
1
0
MCR29402
t
to change settings.
s
to advance to next function.
ts
to exit and save settings.