Makita DBM230 Operating Instructions Manual page 23

Wet and dry diamond core drill

Hide thumbs Also See for DBM230:

Available languages

The following possibilities exist for mounting the P-54190:

Fixing the mount in concrete by means of dowels

Fixing the mount on the floor by vacuum

Do not use vacuum fixing on walls or over-head!

Vacuum fixing may only be used if the area to be drilled is level, free of pinholes

and cracks, otherwise this method cannot be applied.

For the vacuum fixing you need the vacuum set P-54190, vacuum pump and -

hose. They are available on request.

For brickwork, expending anchor

must be used.

Mark the position of the drill holes for the

fixing on the surface to be drilled.

Drill a hole (Ø 15) 50 mm deep (A), into

which the dowel M12 (B) is to be placed;

insert the dowel and secure the dowel with

the doweling tool (C).

Screw the quick action clamping screw (D)

into the dowel.

Install the mount.

Fix the washer (E) and finally the fastening

nut (F) on the quick action clamping screw

(D).

Torque the fastening nut with a SW 27

wrench.

Before and after tightening the nut (F) the

adjustable screws have to be adjusted

Do check whether the mount is installed

safely and firmly.