Installation; Functional Description; Switch Action - Makita 2416S Instruction Manual

SAVE THESE INSTRUCTIONS.

INSTALLATION

Securing cut-off saw
The cut-off saw may be bolted (2 bolts) down to a bench
or floor using the bolt holes in the base. Do not secure
the bolts too tightly.

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.

Switch action

CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and returns
to the "OFF" position when released.
1
011433
The lock-off button and the trigger in the handle must be
pressed for the tool to be activated. You can stop the
motor by releasing the trigger.
CAUTION:
Be sure the switch operates properly. It should turn
•
the tool on and return to the "off" position after
being released.
When not using the tool, remove the lock-off button.
•
This prevents unauthorized operation.
Positioning the spark chute
011424
To prevent sparks from flying around, raise the spark
chute slightly so that point A will be below the base top
1. Switch trigger
2
2. Lock-off button
1. Spark chute
2. Base top
3. Point A
1
2
3
indicated.
CAUTION:
Be sure to adjust the spark chute as mentioned
•
above before operation. Failure to do so will cause
more sparks to fly around causing greater potential
for injury or ignition of any combustible materials
nearby.
Adjusting stopper plate
The stopper plate prevents the wheel from contacting the
surface of the bench floor.
1. When the new wheel is installed, set the stopper
plate as shown in the figure and tighten the thumb
bolt.
1
011426
2. When the wheel wears down to below 355mm
(14" ) in diameter, set the stopper plate as shown
in the figure and tighten the thumb bolt.
011425
3. When the wheel wears down to below 305mm
(12") in diameter, set the stopper plate as shown in
the figure and tighten the thumb bolt.
011427
4
1. Thumb bolt
2. Stopper plate
2