Maintenance - Makita 1051D Instruction Manual

Shiplapping (Rabbeting)
002580
To make a stepped cut as shown in the figure, use the
edge fence (guide rule).
Draw a cutting line on the workpiece. Align the blade
edge with the cutting line. Then adjust the edge fence as
explained in the "Edge fence" section.
1 2
002581
When planing, move the tool with the edge fence flush
with the side of the workpiece. Otherwise uneven planing
may result.
Maximum shiplapping (rabbeting) depth is 15 mm.
CAUTION:
Before shiplapping, adjust the blade so that the end
•
protrudes slightly from the side of the drum.
Chamfering
To make a chamfering cut as shown in the figure, align
the "V" groove in the front base with the edge of the
workpiece and plane it.
It chamfers up to 5.6 mm in a single pass.
5.6 mm (7/32")
002585
1. Blade edge
2. Side of drum
3. Cutting line
3
002586

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before attempting to
perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers, always
using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Mini planer blade
•
Dust bag
•
Various type of Makita genuine batteries and
•
chargers
8
1. V groove
1
or attachments
Only use accessory or
are