Samsung CLX-9201 Service Manual page 321

► Error Code
H2–6735
► Error message
Too much paper in finisher stacker. Remove printed paper.
► Symptom
Finisher output tray is full.
► Troubleshooting method
1) Remove paper from the finisher main tray. Main tray will move downward and upward to clear stack full warning.
2) If warning does not disappear, follow the instructions below :
a) Does finisher main tray input sensor (Standby & Home sensor) work well?
i) Make sure finisher input sensor cable is connected well to the sensor connector.
ii) Make sure finisher input sensor cable is connected well to the main board connector.
iii) Replace the finisher input sensor(JC81–09686A).
(Refer to 3.3.34.1 Finisher Main Motor)
iv) Replace the finisher main board(JC81–09692A).
(Refer to 3.3.34.2. Finisher Board)
b) Does finisher main tray motor work well?
i) Make sure finisher main tray motor cable is connected well to the main tray motor connector.
ii) Make sure finisher main tray motor cable is connected well to the main board connector.
iii) Replace the finisher main tray motor(JC81–09679A).
(Refer to 3.3.34.1 Finisher Main Motor)
Copyright© 1995-2013 SAMSUNG. All rights reserved.
4. Troubleshooting
4-138