AEG ECLIPSE 10 Quick Start Manual page 7

6.1.4 Call from the Call Log
Press in standby mode.
Press to select the desired entry in the call log and then press to dial out the selected call log
number.
Note: You need to subscribe to Caller Line Identification service to be able to see the caller's number or
name in the call log.
6.1.5 Call from the Phonebook
Press in standby mode.
Press to select the desired entry in the phonebook and then press
phonebook number.
6.2 Answer and End a Call
When the phone rings, press on your handset.
To end a conversation, press
Warning: When the handset is ringing, please do not hold it too close to your ear as the volume of the
ringing tone may damage your hearing.
Note: You can simply place the handset back on its base station to end the call, provided you have not
deactivated the Auto hang-up feature.
6.3 Handset Speakerphone
During a call, you can press to alternate between hands-free speakerphone and handset earpiece.
6.4 Adjust Earpiece Volume
There are 5 levels of earpiece volume on your Handset.
During a call, press
>The current setting is shown.
>When you end the call, the setting will remain at the last selected level.
6.5 Adjust Speaker Volume
There are 5 levels of speaker volume.
During a handsfree call, press
>The current setting is shown.
>When you end the call, the setting will remain at the last selected level.
6.6 Mute/Unmute the Microphone
When the microphone is muted, the handset displays "MUTE ON" and your caller cannot hear you.
During a call, press
6.7 Paging
The paging feature enables you to locate a missing handset if the handset is in range and contains
charged batteries.
Press the key under the base unit.
>All the registered handsets that are in range will start to ring.
You can stop the paging by pressing any key on a handset or the
on your handset.
to select from "VOLUME 1" to "VOLUME 5".
to select from "VOLUME 1" to "VOLUME 5".
to turn on/off the microphone.
to dial out the selected
key under the base unit again.