Table of Contents
Advertisement
Getting Started
Quick-Change Battery Removal/Replacement
The quick-change method allows you to remove your
battery at any time and replace it with a charged spare
battery during a telephone call. This is especially useful if
you receive the low battery message ( Lo bAt ) or audible
tone during a call.
Simply remove the battery from the phone and put on the
spare battery. The phone will not go through the normal
power-up cycle described on page 4. You will only have
four seconds to complete this action before your telephone
call is terminated. It is a good idea to practice this
procedure a few times before using it on an actual
telephone call. Advise the party on the other end of the call
before beginning this procedure.
Using Plug-In Chargers
If you are using a charger that plugs into the bottom of the
phone, you must remove the small plastic cover to gain
access to the receptacle, as shown below.
1
Remove
Receptacle
Cover
2
Plug
Connector
into
Receptacle
3
Advertisement
Table of Contents
