Using - Mitsubishi VS-50111, VS-60111, WT-42311, WS-48311, WS-55311, WS-65311, WS-55411, WS-65411, WS-73411 Owner's Manual

Use of the Remote Control with Other A/V Products
VCR
CABLE/DBS/DTV DVD
TV
AUDIO
1
3 DVD/LDP Player Codes
DVD/LDP brand Code to enter:
Mitsubishi (DVD) 003
Mitsubishi (LDP) 016, 017
Panasonic 250
Pioneer DVD (LDP) 252 (016, 017)
Sony 254
Toshiba 253
Zenith 259
To reset to default code, enter 000
Figure 4. Programming the remote to control your DVD/
LDP.
VCR
CABLE/DBS/DTV DVD
TV AUDIO
1
3 A/V Receiver Codes
Audio brand Code to enter:
Mitsubishi A/V receiver
and/or CD player 010, 011
Kenwood 200, 208
Onkyo 209, 214,240
Pioneer 205, 207
Sony 222
Yamaha 201, 202
Harman 215
Teac 210
To reset to default code, enter 000
Figure 5. Programming the remote to control your A/V
receiver.
If the slide switch is set to TV when you
enter an A/V receiver code, VOLUME
and MUTE will control the A/V receiver
rather than the TV. To return volume
and mute control to the TV, set the slide
switch to TV, press and hold POWER
and enter 000.
Some manufacturers may change their
products, or they may use more than
one remote control system. If this is the
case, your remote control may not be
able to operate your VCR, DVD, cable
box, satellite receiver, or A/V receiver.
POWER
2
If your
DVD
code is not
listed here,
please see
This is useful when using an A/V receiver with
page 68
for a
complete
listing.
TV position
POWER
Cable/DBS/DTV position:
2
If your
audio
VCR position:
code is not
listed here,
please see
page 68
DVD position:
for a
complete
listing.
Audio position:
After entering the correct codes in each
position of the remote control, use the slide
switch to select which product will respond
when an operational button is pressed. If you
enter a code from the AUDIO chart while the
slide switch is set to TV, the volume and mute
functions change to match the A/V receiver.
the TV all the time. In all other cases, only
one of the below devices is allowed for each
slide switch position.
:
TV
A/V receiver (volume and mute only)
Cable box
Satellite receiver
DTV receiver
VCR
DVD
LD Player
A/V receiver
Mitsubishi CD player
If you have a Mitsubishi A/V receiver, the
audio position may be used in conjunction
with select Mitsubishi CD players. Your audio
position must be programmed to either 010
or 011. Plug the CD player power cord into
a switched outlet on the back of your A/V
receiver. Pressing the POWER button turns
On the A/V receiver, along with the CD player.
In the audio position, for some CD players,
the transport controls (FF, Play, Rew, etc.)
operate the CD player.
Part lll: Setup
27
27