Mitsubishi VS-50111, VS-60111, WT-42311, WS-48311, WS-55311, WS-65311, WS-55411, WS-65411, WS-73411 Owner's Manual page 72

Cabinet Separation for Models WS-65411 and WS-73411
This Mitsubishi projection television cabinet has been assembled in two pieces.
These pieces may be separated to allow for easier delivery and setup.
The instructions below show how to safely separate and reattach the cabinet.
IMPORTANT IMPORTANT
This projection television weighs over 320 pounds
and has many sensitive components.
This dismantling procedure should be done by
authorized Mitsubishi Dealers or Service Personnel
ONLY.
The following operations should be performed by two
people:
a Remove the decorative Plastic Covers (2) on each
side of the cabinet and then remove the exposed
Screws (2) on each side.
b
Carefully lift the Cabinet-Top straight up until the
Brackets are clear from the Cabinet-Bottom. DO NOT use
the Screen Frame when lifting the Cabinet-Top.
c
Carefully place the Cabinet-Top on to the floor.
d
Once you have moved and positioned the Cabinet-
Bottom to its desired location, reverse the procedure and
mount the Cabinet-Top on the Cabinet-Bottom. Be sure
you align the Brackets properly. Keep fingers clear of all
joints! Replace the Screws and the decorative Plastic
Covers that were removed in Step
72
72
Instructions for Separating the Upper and Lower
Section of the Projection Television Cabinet
For Mitsubishi Dealers and Service Personnel ONLY
a
.
a
Plastic Covers,
Screws
Cabinet-Bottom
c
d