Optional Accessory - Makita DGA405 Instruction Manual

To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
To remove the wheel, follow the installation procedure in
reverse.
Installing or removing Ezynut

(optional accessory)

CAUTION:
Do not use Ezynut with Super Flange or angle
•
grinder with "F" on the end of the model No. Those
flanges are so thick that the entire thread cannot
be retained by the spindle.
012772
Mount inner flange, abrasive wheel and Ezynut onto the
spindle so that Makita Logo on Ezynut faces outside.
1
012773
Press shaft lock firmly and tighten Ezynut by turning the
abrasive wheel clockwise as far as it turns.
Turn the outside ring of Ezynut counterclockwise to
loosen.
1
010846
1. Ezynut
1
2. Abrasive wheel
2
3. Inner flange
4. Spindle
3
4
1. Shaft lock
1. Arrow
2
2. Notch
010863
NOTE:
Ezynut can be loosened by hand as long as the
•
arrow points the notch. Otherwise a lock nut wrench
is required to loosen it. Insert one pin of the wrench
into a hole and turn Ezynut counterclockwise.
Installing or removing flex wheel
(optional accessory)
WARNING:
Always use supplied guard when flex wheel is on
•
tool. Wheel can shatter during use and guard
helps to reduce chances of personal injury.
015312
Follow instructions for depressed center grinding
wheel/flap disc but also use plastic pad over wheel. See
order of assembly on accessories page in this manual.
Installing or removing abrasive disc
(optional accessory)
1
2
3
015313
Mount the rubber pad onto the spindle. Fit the disc on
the rubber pad and screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.
To remove the disc, follow the installation procedure in reverse.
12
1. Lock nut
1
2. Flex wheel
2
3. Plastic pad
4. Inner flange
3
4
1. Sanding lock
nut
2. Abrasive disc
3. Rubber pad