Honeywell LXL-1000 User Manual page 6

System Overview
Security Codes
Zones
Arming, Step-Arming and Disarming Burglary Protection
Alarms
Memory of Alarm
Function Keys
– 6 –
www.PDF-Zoo.com
• You were assigned a 4-digit security code during system installation.
• Use your security code when arming and disarming the system, and when
performing other system functions.
• Other users can be assigned different security codes, each with different
authority levels, which define the system functions a particular user can perform.
• The system sensing devices have been assigned to various "zones," which are specific
areas of protection (e.g., front door, kitchen window, etc.).
displayed at the keypad when an alarm or trouble condition occurs on a sensor.
• The system must be armed before the burglary protection can sense intrusions.
• To arm your system, enter your user code followed by the desired arming key.
• If programmed, the [#] key can be pressed instead of entering the security code
when arming the system.
• You can also use the step-arming feature if programmed, to arm the system. This
is a function key that allows you to arm the system in one of three modes by
simply pressing the key repeatedly.
• To disarm the system, enter your user code, then press the [OFF] key.
• When an alarm occurs, both the keypad and external sounders will sound, and
the keypad will display the zone(s) causing the alarm.
• If your system is connected to a Central Monitoring Station, an alarm message
will also be sent.
• To stop the alarm sounding, simply disarm the system.
• When an alarm condition occurs, the keypad displays the number(s) of the
zone(s) that caused the problem, and displays the type of alarm.
• The message remains displayed even after disarming the system, but can be
cleared with another "off" sequence.
• Some keypads may contain "A," "B," "C," and "D" keys that can be programmed
to perform various functions.
• Functions include: activate a panic alarm, arm the system, provide step arming,
switch lights on/off, send a message to a pager, display Time/Date, and start a
programmed Macro sequence.
(cont'd)
•
Zone numbers are