Using Templates To Configure Phones; Bluetooth Configuration - Cisco 7925G Deployment Manual

Using Templates to Configure Phones

Phone configuration templates can be exported and imported to other phones for quick configuration. The phone configuration
template will be encrypted using the specified encryption key (8-20 characters).
For security reasons, the Wireless LAN security information (Username/Password, WPA Pre-shared key information, and WEP
key information) is not exported by default. In order to export this Wireless LAN security information, the network profile
must be configured to allow this capability. For each network profile where the Wireless LAN security information is to be
exported, configure the "Export Security Credentials" option to "True". After selecting "True", you will need to enter the
Wireless LAN security information again. This will then allow that information to be exported and then imported to other
Cisco Unified Wireless IP Phone 7925G phones.

Bluetooth Configuration

The Cisco Unified Wireless IP Phone 7925G supports Bluetooth to allow wireless headset communications.
To pair a Bluetooth headset to the Cisco Unified Wireless IP Phone 7925G, follow the instructions below.
1. Choose Settings > Phone Settings > Bluetooth
2. Select "Enable" then select the left softkey "Save"
3. Select "Device List"
4. Select "Scan" (ensure the Bluetooth headset is in pairing mode)
5. Select "Pair" after the Bluetooth headset is discovered
6. Enter the Bluetooth passkey (will attempt to use 0000)
7. Select "Connect" after the Bluetooth headset is paired successfully
Cisco Unified Wireless IP Phone 7925G Deployment Guide 69