Cisco 7925G Deployment Manual page 42

Scan Mode
Restricted Data Rates
Power Off When Charging
Cisco Discover Protocol (CDP)
Advertise G.722 Codec
Home Screen
FIPS Mode
Auto Line Select
Below shows the main phone screen (left) and line view (right) display options for the home screen.
Note: If configuring the "Admin Password" in Cisco Unified Communications Manager versions 5.1, 6.0, 6.1, 7.0 or later and
web access is set to "Full", then it is recommended to enable TFTP encryption via the device security profile.
To configure product specific configuration options for the Cisco Unified Wireless IP Phone 7925G with Cisco Unified
Communications Manager Express, create an ephone template with the necessary options.
Cisco Unified Wireless IP Phone 7925G Deployment Guide
Scan mode allows for auto, continuous, and single AP options, where auto
primarily scans only when on call and single AP only at power on.
The restricted data rates feature utilizes the Traffic Stream Rate Set (TSRS)
information element from CCX v4, which can define a data range (upper and
lower) for the client to use (i.e. 12 - 24 Mbps). This can be beneficial for
environments that have legacy clients requiring lower data rates to be enabled on
the access point, but also preventing other clients from downshifting to lower rates,
which lowers overall throughput and capacity. When enabled the Cisco Unified
Wireless IP Phone 7925G will not transmit below 12 Mbps for 802.11a and 11
Mbps for 802.11b/g.
Power off when charging feature will power off the phone when placed on AC
power.
Enables or disables CDP.
G.722 capabilities can be configured on a phone by phone basis and optionally
override the system default.
By default the Cisco Unified Wireless IP Phone 7925G will show the traditional
screen with the four icons for directory, services, settings and line access.
The Federal Information Process Standards (FIPS) mode can optionally be enabled.
When enabled, indicates that the phone will shift the call focus to incoming calls on
all lines. When disabled, the phone will only shift the focus to incoming calls on
the currently used line.
42