Black & Decker SB500 User Manual page 5

Do not use the appliance if the power supply cord or
u
mains plug is damaged or defective.
If the supply cord is damaged, it must be replaced by the
u
manufacturer or an authorised BLACK+DECKER Service
Centre in order to avoid a hazard.
Never attempt to remove or replace any parts other than
u
those specified in this manual.
Electrical safety
Your charger has been designed for a specific voltage. Always
check that the mains voltage corresponds to the voltage on
the rating plate. Never attempt to replace the charger unit with
#
a regular mains plug.
This tool is double insulated in accordance
with EN 60335; therefore no earth wire is
required. Always check that the power supply
corresponds to the voltage on the rating
!
plate.
To avoid the risk of electric shock, do not
immerse the cord, plug or motor unit in water
or other liquid.
Features
This tool may include some or all of the following features
Feature
1. On/Off switch
2. Motor housing
Stainless steel
3.
stem
4. Plastic stem
All purpose
5.
cutting blade
Whisk attachment
6.
7. Measuring cup
Attachment
8.
connector
9. Measuring jug
Ice chopping
10.
blade
11. Chopping blade
Blade mounting
12.
base
13. Gearbox
Lid/Base
14.
Ice chopping
15.
bowl
(Original instructions)
Unpacking
Remove all packaging from the appliance.
u
Clean the appliance before first use.
u
Assembly
Warning! Before assembly, make sure that the appliance is
switched off and unplugged.
Fitting and removing an attachment (Fig.1)
Use the blending attachment (3 or 4) for blending liquids
u
or mashing solids.
Use the whisk attachment (6) for mixing, beating,
u
whipping and creaming liquids.
Use the chopping blade (11), Measuring jug (9), blade
u
mounting base (12) and blade housing (13) for chopping
vegetables etc.
Use the ice chopping blade (15), Measuring jug (9), Ice
u
chopping bowl (12) and blade housing (13) for chopping
ice etc.
Use
Blending
Place the ingredients into a measuring jug or a suitable
u
container.
Using a stabbing motion, push the blades (3 or 4) into
u
the ingredients until the correct consistency is reached.
When blending liquids or fluid ingredients, use short
u
pulses to prevent spillages.
Keeping the blades (3 or 4) submerged will help to
u
prevent spillages. Take extra care when blending hot
ingredients.
Mixing
Place the ingredients into a measuring jug or a suitable
u
container.
Mix the ingredients until the correct consistency is
u
reached.
Keeping the beater submerged will help to prevent
u
spillages. Take extra care when mixing hot ingredients.
Chopping (Fig. 2)
Warning!
The measuring jug (9) must be used with the
chopping blade (11). Do not use the chopping blade with
any other bowl. Do not use the chopping Blade without the
supplied measuring bowl fitted.
Place blade mounting base (12) in the measuring bowl (8)
u
Then place the chopping (11) onto blade mounting base
(12).
ENGLISH
5