Drawer And Cover Removal - GE 19 Use And Care Manual

Storage Drawers

Drawer and Cover Removal

Drawers at the bottom of the
fresh food compartment will stop
before coming all the way out
of the refrigerator, to help prevent
contents from spilling onto the floor.
These drawers can be removed
easily by grasping the sides and
lifting up slightly while pulling
drawers past the "stop" location.
To remove drawers and their cover
when the fresh food compartment
door cannot be opened fully, follow
the procedure that applies to
your model:
Drawers with Glass Cover
1. Remove the drawer farthest
from the door.
2. Remove the other drawer.
On models with a bottom door
shelf that blocks the other drawer,
slide the other drawer toward the
middle and remove it.
3. Remove the glass cover.
Reach in, push the front of the
glass cove; up and, at the same
time, pull it forward as far as it
will come.
12
Upend the cover, tilt it and take it
out.
4. Remove the drawer frame.
(Always remove the glass cover
before you take out the drawer
frame.)
Lift the frame off the supports at
each side and back, pull it forward,
upend it, tilt it and take it out.
To replace:
1. Lower the frame until it
rests on the supports at each
side and back.
2. Replace the drawers.
If you removed the drawer slide,
replace it with the sloped end at
the front.
a. Slide one side of the drawer
onto the drawer slide.
b. Move the slide and drawer all –
the way to the hinge side until the
other side of the drawer rests on
the frame.
c. Slide the other drawer into place.
3. Replace the glass cover, pushing
its rear edge firmly into the rear
frame channel and gently lowering
the front into place.